Add a PLT command to the command list.
XSPEC> setplot command <PLT_command>
where PLT_command is any valid PLT command. Every time you use
setplot command, that command is added to the list that is passed to
PLT when you use plot or iplot. The most common use of setplot
command
is to add a common label to all plots produced. You should be careful
when using this command, because XSPEC does not check to see if you have
entered a valid PLT command. These commands are appended to the list
that XSPEC creates to generate the plot and so setplot command will
override these values (this can either be a bug or a feature, depending
on what you have done!)
See also setplot delete and setplot list.